[the_ad id=”6432″]

This video shows the complete build of a Portable Rocket Mass Heater. This heater goes together like an erector set and comes apart just as easily. It’s custom mini mass. This heater can save you up to 80% on your heating bills. It is super efficient. This heater is beautiful and built completely from reclaimed and repurposed items. This rocket mass heater is Artistic one of a kind! This rocket mass heater is made with air crete, and is budget friendly, handmade, and better than a wood stove.The advantage of this rocket mass heater is the huge increase in the efficiency of capturing and storing the available heat.

Watch the DIY Homemade Efficient Portable Rocket Mass Heater Build Video

[the_ad id=”6432″]

This video shows the generation of Unlimited hot water  100% Off the Grid without electricity by converting an old propane tank to burn underwater as an immersion heater for a lot of hot water.Here,I use a homemade underwater wood stove to make a lot of hot water in a relatively short time.I also make use of the waste heat to cook breakfast.Almost 75-80 gallons of hot water in 1 hour with wood.Really a great way to heat a lot of water.

Watch the DIY Homemade Underwater Wood Stove Water Heater build

[the_ad id=”6432″]

This video shows the build of a redneck style off grid wood burning heat exchange we use to heat our house in the winter. It will keep your home warm without electricity, or using the furnace. The air comes in through the front, where there is a lot of spaces along the bottom of the barrel, then gets heated and rises through the duct in to the house.Here,the air from the house does not go into the exchanger, it only pushes warm air into the house.

Watch the off grid wood burning heat exchanger Build Video

[the_ad id=”6432″]

This video shows the build of a $100K worth WaterJet Cutter for about $200 using a cheap pressure washer.Waterjet is the ultimate machine tool, no matter the application.This is because its a Cold Cutting Process which means no heat or stress is imparted into your cut materials.Also you can take the part directly off of the cutting table, no secondary finishing required.Also it eliminates slag deformation and dross waste – unfortunate effects found in plasma and laser cutting processes.

Watch the DIY Homemade Cheap  WaterJet Cutter Build Video

[the_ad id=”6432″]

This Video shows the build of a DIY Solar Heat Pump System .An air source heat pump consists of an evaporator coil, a condenser, two fans, a compressor, and plumbing lines containing a refrigerant. In simple terms, during the winter the large fan in the outdoor unit pulls cool outdoor air through the evaporator coil which causes the refrigerant inside to absorb what’s called ‘latent heat’ from that air, and then begins to boil and evaporate . Once the refrigerant is up to temperature, it passes through the condenser coil/heat exchanger where indoor air also passes through the condenser’s fins to absorb the heat from the refrigerant and deliver it where it’s needed.A heat pump is essentially an air conditioner working in reverse. Instead of pumping heat from indoors to outdoors, it’s pumping heat in reverse.

Watch the DIY  Solar Heat Pump System Build Video

[the_ad id=”6432″]

This Video series shows step by step on how to build a Homemade DIY Off grid Solar Powered PowerWall Backup System using salvaged and used Chevy Car Batteries.Here we are modifying an 18kwh (Gen 2) battery from an Old Chevy Volt EV hybrid, so that I can use the cells in a DIY Powerwall. The original battery is all wired in series for 355 volts. I’m breaking it down into 8 smaller batteries, each with 44 volts.This DIY Powerwall is using Chevy Volt (Gen 2) batteries instead of the usual Tesla or 18650 cells. This set-up will provide me off-grid backup power in case of an emergency.It’s great that we can re-use and recycle these used car batteries.

Watch the conversion of Old Car Battery into a DIY Solar PowerWall Backup System

[the_ad id=”6432″]

This Video Series shows the build of a Garage heating System which is super insulated, has a radiant floor, and will be heated with the sun. Solar thermal will heat the mass of the concrete floor with hot water. I built this using air-tight and super insulation better than what you would find in a passive house.I set up radiant tubes in the floor for the hot water to circulate. This is a hydronic radiant floor.We add Heat exchanger later to the system which captures the sun’s energy in hot water, and sends it to the radiant floor in my garage/shop.

Watch the DIY Homemade Radiant Floor Garage Heating System Build Videos

[the_ad id=”6432″]

In a survival situation, having light and warmth can mean the difference between merely surviving and actually thriving.Emergency lighting is important to consider if you want to be well prepared. You have more choices than ever when it comes to inexpensive and easy to use lighting.Instead of throwing away your used frying oil, save it for an oil lamp, the old fashioned kind that doesn’t use kerosene or petroleum-based lamp oil.This Video shows the build of a Homemade Emergency Survival Vegetable Oil Candle from an Old Nail Polish Bottle.

Watch the DIY Homemade Emergency Survival Waste Oil Candle Build Video

[the_ad id=”6432″]

Chainsaw mills are a great cost effective way to turn large branches or logs into, slabs, boards or posts. They are very portable and don’t require the serious space or investment of a fully dedicated mill, once you are done milling, simply detach your chainsaw and use it for any of your other tasks. This Video shows the build of a Homemade Chainsaw Mill from Scratch.This is a great tool for builders, outdoors men, and woodworkers. It offers them an inexpensive way of converting their chainsaw into lumber making machines.

Watch the DIY Homemade Alaskan Chainsaw Mill Build Videos

[the_ad id=”6432″]

This Video shows the build of a Homemade Compact “”Counter-Top” Water Distiller which literally cost me nothing to make.It’s made with items commonly found around the home, so for many people, it’s free to make.This Unit Makes Water Fast!.The TDS (total dissolved solids) in the water used was 575-638 ppm. The unit will purify just about any dirty water and works great for converting saltwater to freshwater.No electric power? use propane stoves, rocket-stoves, campfires, parabolic dishes… anything to get the water boiling.Only use Heavy Duty foil for the trough and make trough as smooth as possible for the best water flow. cooling the “condenser bowl” with cold cloths increases water production dramatically.

Watch the DIY Homemade Homemade Water Distiller Build Video