DIY Video:How to build an Easy to make,light,Strong Chainsaw Mill from start to finish.



    RECENT POSTS YOU MIGHT LIKE
    • DIY Video:How to build a Homemade DIY Rocket Stove Boiler to heat your Home.Fully offgrid, cheap and really efficient

      This video shows the step by step complete build of a Hydronic Home heating system by using a DIY Rocket Stove Water Heater.This stove is smokeless and is hooked up to hydronic floors and making hot water 120-127°f output (approx 40°f temp boost @ 4gal/min).The boiler transfers the heat through water tubes in the heat exchanger. The heated water on the other side of the heat exchanger is then delivered to base boards, radiators or in-floor heating tubes throughout your home.The main benefits of this system is that Heat is evenly distributed in a room: no drafts or hot and cold spots as with forced air and hot water from the boiler can also be directed to an indirect water heater to supply your home with hot water

      Watch the DIY homemade DIY Rocket Stove Boiler Build

    • How to build a Homemade Wooden Bandsaw Mill from Scratch.Step by step build Instructions
      This video series shows the build of a Homemade Bandsaw Mill from Start to finish.The design for the saw is a good one, in that it was rock solid as it was making the cuts. Making the saw itself move as opposed to moving the wood through it would really make the build a lot more complex. Beefing up the frame to resist movement (chatter) while cutting through 16" of hard maple would be difficult, especially if the height was also adjustable.Using a stick to lever the wood through the saw was a very good way to regulate a steady feed rate and took little effort. For serious cutting in green, thick hardwood, a 2hp motor doesn't really "cut" it. To make the cutting more efficient (read faster), the blade speed should be very high - as high as 6000 fpm - and a motor that size doesn't have the power. A 6-8 hp gas engine would be much better

      Watch the DIY Homemade Wooden Bandsaw Mill Video series

    • DIY Video : How to build a Homemade Atmospheric Water Generator . Produces/Extracts Distilled Water from the air
      This video shows the build of a Homemade DIY Atmospheric Water Generator!.ThisUnit pulls Pure 'distilled water' straight out of the air. This simple design pumps near freezing water thru a long section of copper coil. Coil becomes very cold and dew (condensate) forms on the coil. The dew is then caught by a drip-pan located beneath the coil.This unit has the added benefit of dehumidifying the air.I used only aluminum and copper in this version. main thing with these is to keep the coils clean. if coils are cleaned after each use, the water generated is 'distilled water.

      Watch the DIY Homemade Atmospheric Water Generator Build Video here