DIY Video:How to Build a Homemade Low Flow Ram Pump that can pump water without Electricity from very low flow creeks ,river.



    RECENT POSTS YOU MIGHT LIKE
    • DIY Video : How to build a Simple Woodgas generator for small electric RV generator
      This video shows the build of a  Simple Woodgas generator for small electric RV generator.A wood gas generator is able to convert wood, or in our case, wood pellets, into a source of fuel which can be used to generate electricity.The wood or charcoal is turned into wood gas, which will be used for powering our generator. In this tutorial, we are creating a wood gas generator that can be used to power and RV motor.From start to finish, we were able to put together this generator in only four hours. In total, we used less than $100 in parts. It’s a great way to build your own wood gas generator while staying on a tight budget.If done correctly, you should be able to run your generator by burning wood pellets alone. It’s enough to power a small 5 hp electric generator, or even more. .The materials you need for this project are 20 Gallon Metal Trash can - This will be used to contain the wine cooler and wood chips as they burn,Wine Cooler - This will encase the wood chips as they are burning,Metal Bowl - You will place the wood chips in this bowl and collect the coals as they burn.Filter - This will filter the tar out as it makes its way to the generator,Wood Pellets - Our fuel source.Aluminum Duct Line - This will connect to the gas generator to the wood pellet burning stove.Air Inlet Port - A valve that we can use to let air in as the wood gas travels to the generator.

      Watch the woodgas generator build videos

    • How to build a Homemade Micro Wind Turbine for under $50 that can be mounted anywhere
      [the_ad id="6432"] In this Video tutorial, we are going to show you how you can build your own homemade wind turbine for under $50.The wind turbine is a nice addition to your solar generator system for times when it’s cloudy and you are not receiving as much sunlight as you normally do.A wind turbine is a perfect backup source energy when your solar is not doing a job. The materials you will need for this project are Permanent Magnet Hobby Motor – The spinning turbine will generate electricity with this motor,Charge Controller - The turbine wires will connect to the charge controller,PVC Pipe - Used for the wings and the stand for the turbine,Wire - To transfer the energy to your batteries.,Drill - Drill holes for the screws,Screws - Secure the wings to the hub.,Sandpaper - Sand the PVC wings so they capture the wind more efficiently,A Sheet of Tin – For the YAW system.

      Watch the DIY Micro Wind Turbine for under $50 Build Video

    • How to run a Homemade Generator on Wood or even Trash/Garbage
      This video series shows how you can run a generator on wood or even trash.When wood is heated it releases a few different types of gases, I use a homemade gasifier to extract these gases out of the wood, I first run the gas through a condenser coil to condense any steam and tar out of the gas, I then use a bubble filter to catch that water and tar and it also helps in filtering out some of the unwanted smoke, next the gas runs through a homemade filter to remove the last of the unwanted byproducts, The wood gas then runs directly into the air intake on the 25cc engine.

      Watch the DIY Homemade Wood Gasifier Build Video