DIY Video:How to build a Homemade Super Efficient Portable Solar Generator.Really Flexible…


This video series shows the build of a DIY 110 amp hour portable generator is designed to be powered by a 100W solar panel and 2 55AH AGM sealed batteries. The system includes a 30A PWM solar charge controller and a 400W pure sine wave inverter. 12V, 12V USB, and 110V AC outlets offer flexibility for powering/charging a variety of appliances. The system is also set up to be trickle charged via a SAE 2-pin port that allows for a convenient connection to an AC float charger.Total cost of all materials required to build this proj.ect, including all components of the generator and the solar panel, was approximately $950 USD.The parts lists and the wiring schematic is included at the end of the series

Watch the DIY Homemade 100W /100 Amp hour Portable Solar generator build



RECENT POSTS YOU MIGHT LIKE
  • How to build a Simple Homemade Water Distiller.Great for emergency or everyday use.
    This video shows the build of a Deluxe "Stainless Steel" Pure Water Still.This Distills all types of Dirty-water/Salt-water to a clean fresh drinking water.The materials you need for this project are : the 24" stainless steel supply lines are 3/4". the pvc piece is 1 1/4" OD to 3/4" threaded. the coupler is 1 1/4" to 1 1 /4". (adjust these as necessary to your specific kettle)Made using a stainless steel teapot and 6 feet of stainless steel tubing,this can either be used on a standard stove burner or rocket stove/campfire/parabolic dish for total off-grid operation. This assembles/disassembles fast for easy portability.This produces water about 50% faster than my standard stainless steel design

    Watch the DIY Homemade Pure Water Still Build Video

  • How to build an awesome Drill Powered Winch .Lift a Car or other Heavy loads effortlessly using a simple Cordless Drill
    This video shows how a simple Cordless Drill can effortlessly lift or move heavy loads. Definitely beats a Come Along.The winch in the video was purchased from Harbor Freight.With a snatch block this will lift 4000lbs which will pull a 20,000lb vehicle up a 10% grade.A snatch block is a really neat thing. By taking the cable out of the winch and through the pulley of the snatch block, then back to the winch it doubles the pull capacity. It also halves the speed of the item being pulled/lifted but it is a worthwhile trade off. You can keep adding pulleys and running back and forth to reduce the strain on the winch.You will see that a cordless drill lifting a car off the ground is pretty damn impressive

    Watch the DIY Homemade Cordless Drill Powered Winch Build Video

  • DIY Video : How to heat your garage the Inexpensive way by building an Outdoor Stove with Heat Exchanger
    This video shows you how to make a 55 gallon Barrel Stove with Heater Exchanger to heat your garage .This one uses a 30 gallon drum which goes inside the 55 gallon drum and the 55 gallon drum is used as a heat exchanger.The heat exchanger assists heat transfer to the room, largely determining how much wood is used. Heat exchangers increase heat transfer to the room by making sure that the hot flue gases leaving through the chimney are as cool as possible. The pipe goes into the garage through a 4 inch hole .

    Watch the DIY Homemade Barrel Stove Heater Exchanger for your garage Videos