DIY Video:How to build a Simple Homemade Wind Generator from Old Ceiling Fan ,Microwave Oven Parts ,Old TV Antenna and other free junk



    RECENT POSTS YOU MIGHT LIKE
    • How to build a Homemade Hybrid Waste Oil and Wood Garage Heater
      This Video shows the setup of a Wood and Waste Oil Combo Gargage heater .With prices of everything going up, families need to figure out ways to save money however they can. In many ways, saving money involves cutting back on waste and using things that would normally just be thrown away for a more effective purpose.Waste oil comes from many different sources such as cooking oil, used vegetable oil, or motor oil. This can help to raise the heat produced by a cord of wood and extend the life of the wood as the waste oil is burned alongside it.

      Watch the DIY Homemade Hybrid Wood and Waste Oil Garage Heater Build

    • DIY Video :How to build a Simple and Efficient Copper Coil Burner Stove from start to finish.Great in a emergency/disaster or while out camping
      This video shows the build of a Simple Homemade Copper Coil Burner Stove. Works great and would be perfect for cooking or boiling water, either in an emergency/disaster or while out camping.This is made out of a canning jar which was picked up from Walmart.The other materials required are some copper tubing,strong glue like jb kwik weld,couple of drill bits,wick material.This is really easy to make and works really efficiently.

      Watch the Homemade  Simple Copper Coil Burner Stove Build

    • How to build a Homemade Wooden Bandsaw Mill from Scratch.Step by step build Instructions
      This video series shows the build of a Homemade Bandsaw Mill from Start to finish.The design for the saw is a good one, in that it was rock solid as it was making the cuts. Making the saw itself move as opposed to moving the wood through it would really make the build a lot more complex. Beefing up the frame to resist movement (chatter) while cutting through 16" of hard maple would be difficult, especially if the height was also adjustable.Using a stick to lever the wood through the saw was a very good way to regulate a steady feed rate and took little effort. For serious cutting in green, thick hardwood, a 2hp motor doesn't really "cut" it. To make the cutting more efficient (read faster), the blade speed should be very high - as high as 6000 fpm - and a motor that size doesn't have the power. A 6-8 hp gas engine would be much better

      Watch the DIY Homemade Wooden Bandsaw Mill Video series