How to build a Homemade Archimedes Screw Turbine using PVC parts to generate Off the grid Power from a flowing river or stream/creek

Flume Build :

https://www.youtube.com/watch?v=urwnHDWe8IY[/vc_column_text][/vc_column][/vc_row]



RECENT POSTS YOU MIGHT LIKE
  • How to build a super Efficient Wood Burner from start to finish .No smoke and Clean Burn
    This Video series shows the build of a wood burner/heater from an gas cylinder from start to finish.The video begins by explianing the cutting of flue /ash pan hole in top and bottom. Main materials from the local scrapyard made new.Then door is cut out, door frame built,secondary air pipework,flue deflector plate.The next in the series shows the fitting flue deflector plate,drilling bending and fixing the les,grinding all old welds off, making lifting handles,flue outlet and drilling the secondary air intake hole,making the door hinges,cutting hole out for glass in door,welding secondary air intake pipes in.The series ends with making the secondary air intake,door frame welded,primary air damper built and welded on.A Test burn is shown at the end.

    Watch the build of a Homemade Efficient Wood Burner from scratch

  • DIY Video :How to heat your Home by building an Smokeless Outdoor Wood Boiler from Start to finish
    This video series shows the build of a smokeless wood burning boiler from start to finish.It is built from a old hot water tank and a small air compressor tank and costs next to nothing to build.The first video of the series  will show the construction of the boiler itself. The next video will detail how to hook it up to a pump and exchanger to bring the heat inside. The final video will show modifications I make to the stove to make it even more efficient.

    Watch the build of a Homemade Smokeless Outdoor Wood Video Series

  • How to build a Homemade Micro Wind Turbine for under $50 that can be mounted anywhere
    [the_ad id="6432"] In this Video tutorial, we are going to show you how you can build your own homemade wind turbine for under $50.The wind turbine is a nice addition to your solar generator system for times when it’s cloudy and you are not receiving as much sunlight as you normally do.A wind turbine is a perfect backup source energy when your solar is not doing a job. The materials you will need for this project are Permanent Magnet Hobby Motor – The spinning turbine will generate electricity with this motor,Charge Controller - The turbine wires will connect to the charge controller,PVC Pipe - Used for the wings and the stand for the turbine,Wire - To transfer the energy to your batteries.,Drill - Drill holes for the screws,Screws - Secure the wings to the hub.,Sandpaper - Sand the PVC wings so they capture the wind more efficiently,A Sheet of Tin – For the YAW system.

    Watch the DIY Micro Wind Turbine for under $50 Build Video