How to build a Simple Homemade Water Distiller.Great for emergency or everyday use.

This video shows the build of a Deluxe “Stainless Steel” Pure Water Still.This Distills all types of Dirty-water/Salt-water to a clean fresh drinking water.The materials you need for this project are : the 24″ stainless steel supply lines are 3/4″. the pvc piece is 1 1/4″ OD to 3/4″ threaded. the coupler is 1 1/4″ to 1 1 /4″. (adjust these as necessary to your specific kettle)Made using a stainless steel teapot and 6 feet of stainless steel tubing,this can either be used on a standard stove burner or rocket stove/campfire/parabolic dish for total off-grid operation.

This assembles/disassembles fast for easy portability.This produces water about 50% faster than my standard stainless steel design

Watch the DIY Homemade Pure Water Still Build Video



RECENT POSTS YOU MIGHT LIKE
  • DIY Video : How to get Gold from Scrap Computer parts that you can find at the junkyard
    [the_ad id="6432"] These series of videos shows how to easily Refine and Smelt Gold from Computer Memory Chips. In the first video I'm recovering Gold from computer Memory Chips (RAM).The Part 2 video on how to take the gold from computer chips and refine it to a more pure metal and smelt it.In Part 3 video, I'm doing a purity test on the gold I recovered from the computer memory chips.If you follow this process, you will be able to convert all of your old and outdated computer chips into pure gold that you can turn around and sell for money. It’s a great way to salvage your old electronics and get some value out of them.

    Watch the Gold extracting process from Scrap Computer parts

  • How to build a Homemade Wooden Bandsaw Mill from Scratch.Step by step build Instructions
    This video series shows the build of a Homemade Bandsaw Mill from Start to finish.The design for the saw is a good one, in that it was rock solid as it was making the cuts. Making the saw itself move as opposed to moving the wood through it would really make the build a lot more complex. Beefing up the frame to resist movement (chatter) while cutting through 16" of hard maple would be difficult, especially if the height was also adjustable.Using a stick to lever the wood through the saw was a very good way to regulate a steady feed rate and took little effort. For serious cutting in green, thick hardwood, a 2hp motor doesn't really "cut" it. To make the cutting more efficient (read faster), the blade speed should be very high - as high as 6000 fpm - and a motor that size doesn't have the power. A 6-8 hp gas engine would be much better

    Watch the DIY Homemade Wooden Bandsaw Mill Video series

  • DIY Video: How to build a Homemade Gravity fed ,Drip Waste Oil Heater for your Garage . Really Efficient…..Good heat.
    This video shows the build of a gravity fed, drip waste oil burner .This is the one of the simplest design for maximum heat and flexibility .The concept behind this burner is that Oil does not burn, but the fumes it gives off when the oil is boiling.The deeper the pan the harder is it to maintain an efficient boil.A cast iron pan maintains the higher temperature the best and does not threaten to burn through.The secondary holes in the vertical pipe are where the actual burn is occurring.The materials needed for this build are Air compressor tank,Pan that has been burnt for about one and half hour,Oil, like motor oil,Flamer,Chimney pipe (with length of about ten feet).This setup creates a lot of carbon in and around the burning chamber, but does not smoke at all.It will run about 400-500 degree Celsius (at the base) at under or up-to 1L per hour

    Watch the DIY Homemade Drip fed Waste/Engine Oil Burner/heater build Videos