DIY Video: How to build a Band Sawmill from scratch in your backyard and save a lot of money. Step by step build instructions.

     



    RECENT POSTS YOU MIGHT LIKE
    • DIY Video :How to build a Simple Backyard Water Filtration System from easily available materials .Step by step Video Instructions
      This video shows step by step in detail the build of a simple backyard Water Filtration and purification System .This is a simple type of water purification system that uses sand, gravel, gravity and some simple engineering to purify water contaminated with biologics and some chemicals.As water flows through the filter, physical straining removes pathogens, iron, turbidity and manganese from drinking water. A shallow layer of water sits atop the sand and a biofilm. The biofilm contributes to the removal of pathogens due to predation and competition for food of non-harmful microorganisms contained in the biofilm and the harmful organisms in the water.Turn non-potable water into quality drinking water with this inexpensive Water filter.

      Watch the DIY Homemade Bio-sand Water Filtration System Build

    • DIY Video:How to build an Easy to make,light,Strong Chainsaw Mill from start to finish.
      Harvesting and processing the wood that grows on your property is the dream of many homesteaders. The dream can be expensive (around $5k) because you need a sawmill in order to rip the wood and remove the bark.Instead of spending years saving up, you can spend less by building your own saw mill out of a chainsaw!.This video shows the build of an easy to make,light and strong Chainsaw mill from scratch.You will need some 2mm,3mm square pipes, coarse threads,bolts,spring washers

      Watch the DIY Homemade Simple Chainsaw Mill Build

    • DIY Video : How to build a DIY Pex Coil Solar Thermal Water Heater. Simple and Efficient!!
      This video shows the build of a Simple Pex Coil Solar Thermal Water Heater.asy DIY! No Soldering, Clamps, Crimp Rings, Glues, Unions, or that expensive crimping tool! in my design it's just 2 push-to-fit "shark-bite" connectors! (located outside of collector) and because it's all one piece of tube, the unit has no potential internal leak points.PEX is sturdy, tough and rigid. water temp rating range... 33F to 185F-200F (93°C) water! ...and if temps hit or fall below 32F (0°C) it's freeze damage resistant! it'll freeze but doesn't break. the connectors are made to last at least 25 years and pipe is rated 50+ years.

      Watch the DIY Homemade Solar Thermal PEX COIL Water Heater Build Video