DIY Video : How to build a Simple and Efficient Homemade Water Distiller for cheap .Great for everyday use or in emergency/off-grid situations.



    RECENT POSTS YOU MIGHT LIKE
    • How to build an Emergency Deep Well Water Pump from scratch.Step by step build Instructions
      Considering that most disasters can cause serious disruptions in the water supply and the importance of water for survival, putting in a well is a great idea. Of all the possible sources for water, having a well on your own property is the most secure source you can have.This video series shows step by step the build of a Homemade Deep Well Water Pump.Even so, if the grid goes down, that water could be out of your reach, if you don’t take the right precautions.

      Watch the DIY Homemade Emergency Deep Well Water Pump series

    • DIY Video : How to build a Powerful Mini Box fan for or off-grid use, camping, emergencies or everyday use
      This Video shows the build of a Homemade 12VDC Mini Box Fan! w/motor speed control!Powered with a 12v battery or 12v solar panel! Made Sturdy and is SUPER POWERFUL! pushes more air than a fan twice its size.Ithas a whopping 1500 CFM air-flow volume with wind speeds measuring in at over 20 MPH! (32 kph) and with the motor control switch you can set it to run at any of 100 different speeds! .Great for off-grid use, camping, emergencies or everyday use. tip: run it from a cars' 12v cigarette lighter plug.

      Watch the DIY Homemade 12VDC Mini Box Fan Build Video

    • DIY Video:How to build a Homemade Double Barrel Garage Heater out of Old Water Tanks .Efficient,clean burn and cheap!
      This project goes over the build of Double Barrel Stove out of two old scrap water heaters for the shop. The first step is to disassemble both the old electric hot water heaters to get their tanks out. Take a grinder and cut a section off from the top of the water heater tank. This tank will become the bottom tank. Remove any calcium and mineral that ends up developing deposits inside the bottom of the tank. Take a 12 gauge plate steel and put our top drum upside down and scribe a circle out of them from the end and cut it. Weld the steel piece onto the drum. You need to do the same for the other drum too because with these double barrels, you are basically making two stoves, just connecting them in the middle. Now both the top tank and bottom tank ends have been polished and cleaned .Remove any insulations, paints and glues from them if they have any. Make sure all the rough pieces on the tank are welded on ground down. Cut a small piece of pipe that acts as stack between the 2 tank. Next step is to add a small support bracket on the top of the bottom tank that will help support the top tank. Cut a hole on the bottom tank .This will be where the stack goes between two of them. Fill the drain plug down at the bottom . Take the top tank, cut and weld the top exhaust stack that will be six inch outlet for the smoke. We also add a six inch inlet that goes up to the top that forces your your smoke and the gas has to go across the length of the barrel. The bottom barrel will be connected to this. Both barrels are welded together, the bottom barrel is welded onto the mid stack which connects the top barrel with the exhaust stack. In order to support the barrels, we take the scrap pipes lying around and make legs as a support structure for the stove. Next is the door fabrication. We cut a hole for the door in the bottom barrel. A couple of hinges, door catch are welded on to this end. An air inlet pipe is threaded onto a plate. The whole unit is then attached to the door. A handle is attached to the inlet pipe so you can open and close whenever you want to control the flow of the air intake. https://www.youtube.com/watch?v=fTj4pjJ4DT0