How to build an Efficient and Inexpensive Double Barrel Garage Heater from Scrap metal.Step by step Video Instructions

    This video series shows the step by step build of a my barrel stove project without the kit.I’m building this with crap metal I have laying around the shop to avoid spending any money at all on this kit.The 2nd barrel makes the stove more efficient. With a single barrel you loose a ton of heat out of the chimney not to mention the more heat that stays within the stove means the cleaner it will burn. In my opinion the 2nd barrel is an absolute must. But yes it is warmer because you do not loose nearly as much heat.

    Watch the DIY Homemade Inexpensive Double Barrel Garage Heater Build Videos



    RECENT POSTS YOU MIGHT LIKE
    • How to build a Homemade Micro Wind Turbine for under $50 that can be mounted anywhere
      [the_ad id="6432"] In this Video tutorial, we are going to show you how you can build your own homemade wind turbine for under $50.The wind turbine is a nice addition to your solar generator system for times when it’s cloudy and you are not receiving as much sunlight as you normally do.A wind turbine is a perfect backup source energy when your solar is not doing a job. The materials you will need for this project are Permanent Magnet Hobby Motor – The spinning turbine will generate electricity with this motor,Charge Controller - The turbine wires will connect to the charge controller,PVC Pipe - Used for the wings and the stand for the turbine,Wire - To transfer the energy to your batteries.,Drill - Drill holes for the screws,Screws - Secure the wings to the hub.,Sandpaper - Sand the PVC wings so they capture the wind more efficiently,A Sheet of Tin – For the YAW system.

      Watch the DIY Micro Wind Turbine for under $50 Build Video

    • How to build a Simple Homemade Water Distiller that turns dirty water/salt water into clean fresh pure water
      [the_ad id="6432"] This video shows the build of a "pure water" Water Distiller that easily turns dirty water/salt water etc... into clean fresh pure water. This produces lots of clean water fast. Made from close to 12 feet of copper tubing along with a few fittings (optional stainless steel tube shown as well). video contains full instructions on how to build it. Early testing shows it produces about a quart in 1.5 hrs (and half gallon in 2.5 hrs). note that i soldered on the copper fitting. If you don't have a torch, they sell "push on" fittings that require no soldering. *if soldering, remember to use "lead-free" solder.The process is simple. It boils water and creates steam. The steam rises without bringing any of the impurities along with it. The steam travels through the coils and slowly cools and condenses. It finally condenses back to its liquid form and drips out as clean water.

      Watch the DIY Deluxe Pure Water Distiller build

    • DIY Video:How to convert an Old Ceiling Fan Motor into a 40W Efficient Alternator Generator
      This video shows an easy conversion of an Old Ceiling Fan motor into a Power producing 40 Watt 200V 3000RPM Alternator Generator that can used for powering your devices.The ceiling fan motors have the stator in the center and the outer portion that usually attaches to the fan blades rotates around the stationary stator. This allows for Neodymium Magnets to be placed around the perimeter. When the outer portion spins, it produces an alternating current. For conversion of an alternating current (AC) input into direct current a (DC) output, a bridge rectifier is used

      Watch the DIY Homemade Ceiling Fan Motor conversion Video