How to build an Efficient and Inexpensive Double Barrel Garage Heater from Scrap metal.Step by step Video Instructions





    Update :



    RECENT POSTS YOU MIGHT LIKE
    • How to build an Inexpensive Geothermal Air Conditioning System to Cool your Home using an Old Car Radiator ,Solar Panel.
      This video series shows you how to make a geothermal cooling system to cool your home with the Earths natural cool temperature.10–15 feet underground, the temperature remains between 55 and 60 degrees Fahrenheit. This is true regardless of the weather above ground.The geothermal unit siphons heat from inside and vents it into the water or refrigerant in the loop. The cool temperature underground then lowers the temperature of the liquid back to 55 degrees.This cooler temperature can be used to cool your home efficiently .This build uses an old car radiator to circulate the air using a Solar Panel.

      Watch the Homemade cheap Geothermal Cooling System Series

    • DIY Video:How to build an Emergency Water Distillation Still for Survival Bug-Out Bag
      This video shows the build of a Emergency Water Distillation Portable Still that removes biological, salt and heavy metal contamination from drinking water.The still is made by putting an upside-down stainless steel funnel over a pot of boiling water as a lid. Ideally the pot is designed for cooking, but in an emergency any metal container, such as a soda can, may be used. Connect a 1/2 inch diameter copper pipe to the funnel with three 45 degree elbow fittings. Put a damp rag on the pipe to condense the steam. Fresh, drinkable water will drip out of end of the pipe

      Watch the DIY Homemade Emergency Water Distillation Still Build

    • DIY Video:How to build a Homemade Super Efficient Portable Solar Generator.Really Flexible…
      This video series shows the build of a DIY 110 amp hour portable generator is designed to be powered by a 100W solar panel and 2 55AH AGM sealed batteries. The system includes a 30A PWM solar charge controller and a 400W pure sine wave inverter. 12V, 12V USB, and 110V AC outlets offer flexibility for powering/charging a variety of appliances. The system is also set up to be trickle charged via a SAE 2-pin port that allows for a convenient connection to an AC float charger.Total cost of all materials required to build this proj.ect, including all components of the generator and the solar panel, was approximately $950 USD.The parts lists and the wiring schematic is included at the end of the series

      Watch the DIY Homemade 100W /100 Amp hour Portable Solar generator build