How to generate Free and Emergency hot water for your house by building a Waste Oil powered water heater



RECENT POSTS YOU MIGHT LIKE
  • DIY Video:How to build a Large 2000W Solar Power Generator at Home from scratch.Step by step Build Instructional Videos
    This video series shows the step by step build of a large 2000W Solar Generator that can run most of your home appliances.The idea of a completely silent generator that can run large power loads while never needing gasoline is a really cool concept. Whether you want to run a portable table saw, or go tailgating / camping where the noise of a standard generator would just be irritating, we will show you step-by-step how to build a weatherproof indoor/ outdoor solar generator

    Watch the step by step 2000W Solar Power Generator Build Videos

  • How to build a Simple Survival Water Distiller using Bottles
    This video shows the build of a Simple Solar Water Distillation System for survival/SHTF situations.This is made using 2 clear (plastic or glass) bottles and glue (or tape).Fill one bottle with dirty/or saltwater,then connect the second bottle and set in the sun.Within a few minutes the water begins to evaporate and the other bottle collects the clean distilled water vapor.make sure the bottles have an airtight connection. prop up bottles at a slight angle so as the dirty/or saltwater starts to evaporate - the max. amount of water vapor will travel up to the higher collection container. works best in bright sun.

    Watch the DIY homemade Survival Water Distiller Build

  • How to build a Simple Homemade Water Distiller that turns dirty water/salt water into clean fresh pure water
    [the_ad id="6432"] This video shows the build of a "pure water" Water Distiller that easily turns dirty water/salt water etc... into clean fresh pure water. This produces lots of clean water fast. Made from close to 12 feet of copper tubing along with a few fittings (optional stainless steel tube shown as well). video contains full instructions on how to build it. Early testing shows it produces about a quart in 1.5 hrs (and half gallon in 2.5 hrs). note that i soldered on the copper fitting. If you don't have a torch, they sell "push on" fittings that require no soldering. *if soldering, remember to use "lead-free" solder.The process is simple. It boils water and creates steam. The steam rises without bringing any of the impurities along with it. The steam travels through the coils and slowly cools and condenses. It finally condenses back to its liquid form and drips out as clean water.

    Watch the DIY Deluxe Pure Water Distiller build