How to process your own Firewood by building a Cheap log spiltter made out of Scrap materials



This 3 part Video series shows the build of a hydraulic log splitter for cheap, by salvaging parts you can build a DIY splitter that will help with processing your firewood.  the Total cost was about $400 to build.I had the 6.5 hp motor from another project, I salvaged all of the metal , some of the scrap came from my work.We used our CNC plasma torch on this project and It made quick work cutting out all of the parts, But one could always free hand cut all the parts fairly easily with a torch.

Watch the Homemade  Cheap log spiltter Build Series



RECENT POSTS YOU MIGHT LIKE
  • How to build a Simple Homemade Water Distiller that turns dirty water/salt water into clean fresh pure water
    [the_ad id="6432"] This video shows the build of a "pure water" Water Distiller that easily turns dirty water/salt water etc... into clean fresh pure water. This produces lots of clean water fast. Made from close to 12 feet of copper tubing along with a few fittings (optional stainless steel tube shown as well). video contains full instructions on how to build it. Early testing shows it produces about a quart in 1.5 hrs (and half gallon in 2.5 hrs). note that i soldered on the copper fitting. If you don't have a torch, they sell "push on" fittings that require no soldering. *if soldering, remember to use "lead-free" solder.The process is simple. It boils water and creates steam. The steam rises without bringing any of the impurities along with it. The steam travels through the coils and slowly cools and condenses. It finally condenses back to its liquid form and drips out as clean water.

    Watch the DIY Deluxe Pure Water Distiller build

  • DIY Video :How to build a Simple Backyard Water Filtration System from easily available materials .Step by step Video Instructions
    This video shows step by step in detail the build of a simple backyard Water Filtration and purification System .This is a simple type of water purification system that uses sand, gravel, gravity and some simple engineering to purify water contaminated with biologics and some chemicals.As water flows through the filter, physical straining removes pathogens, iron, turbidity and manganese from drinking water. A shallow layer of water sits atop the sand and a biofilm. The biofilm contributes to the removal of pathogens due to predation and competition for food of non-harmful microorganisms contained in the biofilm and the harmful organisms in the water.Turn non-potable water into quality drinking water with this inexpensive Water filter.

    Watch the DIY Homemade Bio-sand Water Filtration System Build

  • How to build a Homemade 79CC Motorized Bug Out Vehicle from start to finish ……Step by step Video Instructions
    [the_ad id="6432"] This Seven Part Video series step by step shows the build of a Homemade Gas Powered 79CC 3 Gear Motorized Bike using a roadmaster bicycle.The engine used here is 79CC harbor Frieght 4 Stroke Engine.The first part shows the components needed for the entire build.The second Video shows how I finish the jack shaft going to the rear wheel on my bike.The third Video shows a small test ride with the bike and also shows how to set up 2nd and 3rd gear as well as throttle and some other things.The 4th vid shows how i put the gas tank on the motorized bike.The rest of the videos shows the miscellaneous changes made to the rough build ,doing some little things here and there.The last Video shows a sample test ride

    Watch the DIY Homemade 79CC 3 Gear Motorized Bug Out Vehicle Build series