DIY Video: How to build a Homemade Gravity fed ,Drip Waste Oil Heater for your Garage . Really Efficient…..Good heat.



    RECENT POSTS YOU MIGHT LIKE
    • How to build a Homemade Hybrid Waste Oil and Wood Garage Heater
      This Video shows the setup of a Wood and Waste Oil Combo Gargage heater .With prices of everything going up, families need to figure out ways to save money however they can. In many ways, saving money involves cutting back on waste and using things that would normally just be thrown away for a more effective purpose.Waste oil comes from many different sources such as cooking oil, used vegetable oil, or motor oil. This can help to raise the heat produced by a cord of wood and extend the life of the wood as the waste oil is burned alongside it.

      Watch the DIY Homemade Hybrid Wood and Waste Oil Garage Heater Build

    • DIY Video:How to build a Large 2000W Solar Power Generator at Home from scratch.Step by step Build Instructional Videos
      This video series shows the step by step build of a large 2000W Solar Generator that can run most of your home appliances.The idea of a completely silent generator that can run large power loads while never needing gasoline is a really cool concept. Whether you want to run a portable table saw, or go tailgating / camping where the noise of a standard generator would just be irritating, we will show you step-by-step how to build a weatherproof indoor/ outdoor solar generator

      Watch the step by step 2000W Solar Power Generator Build Videos

    • DIY Video: How to build a Homemade Gravity fed ,Drip Waste Oil Heater for your Garage . Really Efficient…..Good heat.
      This video shows the build of a gravity fed, drip waste oil burner .This is the one of the simplest design for maximum heat and flexibility .The concept behind this burner is that Oil does not burn, but the fumes it gives off when the oil is boiling.The deeper the pan the harder is it to maintain an efficient boil.A cast iron pan maintains the higher temperature the best and does not threaten to burn through.The secondary holes in the vertical pipe are where the actual burn is occurring.The materials needed for this build are Air compressor tank,Pan that has been burnt for about one and half hour,Oil, like motor oil,Flamer,Chimney pipe (with length of about ten feet).This setup creates a lot of carbon in and around the burning chamber, but does not smoke at all.It will run about 400-500 degree Celsius (at the base) at under or up-to 1L per hour

      Watch the DIY Homemade Drip fed Waste/Engine Oil Burner/heater build Videos