DIY Video:How to build a Homemade DIY Rocket Stove Boiler to heat your Home.Fully offgrid, cheap and really efficient

[the_ad id=”7799″]

This video shows the step by step complete build of a Hydronic Home heating system by using a DIY Rocket Stove Water Heater.This stove is smokeless and is hooked up to hydronic floors and making hot water 120-127°f output (approx 40°f temp boost @ 4gal/min).The boiler transfers the heat through water tubes in the heat exchanger. The heated water on the other side of the heat exchanger is then delivered to base boards, radiators or in-floor heating tubes throughout your home.The main benefits of this system is that Heat is evenly distributed in a room: no drafts or hot and cold spots as with forced air and hot water from the boiler can also be directed to an indirect water heater to supply your home with hot water

Watch the DIY homemade DIY Rocket Stove Boiler Build

This video shows the generation of Unlimited hot water  100% Off the Grid without electricity by converting an old propane tank to burn underwater as an immersion heater for a lot of hot water.Here,I use a homemade underwater wood stove to make a lot of hot water in a relatively short time.I also make use of the waste heat to cook breakfast.Almost 75-80 gallons of hot water in 1 hour with wood.Really a great way to heat a lot of water.

Watch the DIY Homemade Underwater Wood Stove Water Heater build


[the_ad id=”7799″]
This Video series shows how to Repurpose an Old Water heater into a Foundry Furnace.This is a great way for the do-it-yourselfer to build a foundry furnace that will last a long time, heat up quickly, be fuel efficient, easy to build, and not break the bank!.The materials needed for this build are Old Water heater,Non-firing refractory,100HT ceramic coating,Ceramic blanket.

Watch the Old Water Heater Foundry Build Series here


[the_ad id=”7799″]
This video shows the build of a Homemade DIY Atmospheric Water Generator!.ThisUnit pulls Pure ‘distilled water’ straight out of the air. This simple design pumps near freezing water thru a long section of copper coil. Coil becomes very cold and dew (condensate) forms on the coil. The dew is then caught by a drip-pan located beneath the coil.This unit has the added benefit of dehumidifying the air.I used only aluminum and copper in this version. main thing with these is to keep the coils clean. if coils are cleaned after each use, the water generated is ‘distilled water.

Watch the DIY Homemade Atmospheric Water Generator Build Video here

[the_ad id=’7799′]

This video series shows you how to make a geothermal cooling system to cool your home with the Earths natural cool temperature.10–15 feet underground, the temperature remains between 55 and 60 degrees Fahrenheit. This is true regardless of the weather above ground.The geothermal unit siphons heat from inside and vents it into the water or refrigerant in the loop. The cool temperature underground then lowers the temperature of the liquid back to 55 degrees.This cooler temperature can be used to cool your home efficiently .This build uses an old car radiator to circulate the air using a Solar Panel.

Watch the Homemade cheap Geothermal Cooling System Series