How to build a Homemade 79CC Motorized Bug Out Vehicle from start to finish ……Step by step Video Instructions

[the_ad id=”6432″]
This Seven Part Video series step by step shows the build of a Homemade Gas Powered 79CC 3 Gear Motorized Bike using a roadmaster bicycle.The engine used here is 79CC harbor Frieght 4 Stroke Engine.The first part shows the components needed for the entire build.The second Video shows how I finish the jack shaft going to the rear wheel on my bike.The third Video shows a small test ride with the bike and also shows how to set up 2nd and 3rd gear as well as throttle and some other things.The 4th vid shows how i put the gas tank on the motorized bike.The rest of the videos shows the miscellaneous changes made to the rough build ,doing some little things here and there.The last Video shows a sample test ride

Watch the DIY Homemade 79CC 3 Gear Motorized Bug Out Vehicle Build series



RECENT POSTS YOU MIGHT LIKE
  • DIY Video:How to recycle scrap metal in the backyard by building a simple Mini Metal Foundry from start to finish
    This video shows you how to recycle scrap metal in the backyard, with a homemade, Mini Metal Foundry.Depending on where you get, or find, your materials the cost can range anywhere from $5-$25 per unit. With the materials I used, I was able to make 2 units for under $40 ($20 each).Even on the high end, this is probably one of the cheapest, reliable, backyard foundries that can be made.I used mine to melt soda cans, and extract the aluminum for future metal casting projects. All the soda cans came from a local recycling depot.
    Watch the Homemade Mini Metal Foundry  Build
  • How to build a simple Homemade PVC Off grid River Pump to pump water from a river or creek
    This video shows the build of a river pump  that you can use to pump water from a nearby river or creek anywhere you want. It works by harnessing the flow of the river and creating air pressure to push the water further.It pushes water out from the river and up through your hose system, which you can direct where needed. To use a river pump, all you need is a nearby river or creek that has flowing water and a location that is deep enough to support your river pump. As long as you have that and the necessary supplies, you are good to go.

    Watch how to build a simple Homemade PVC Off grid River Pump to pump water

  • How to build a Simple and Efficient Homemade Garage Fan out of Old Furnace Blowers
    This video shows the build of a Homemade Garage fan made out of Old Furnace blowers that is easy to make and really efficient.Once you try one of these you'll never use a box fan again. These fans are designed to run with constant restriction. So you need to recreate this when used out in the open by blocking roughly 25% of the air intake or output. If you don't restrict the airflow the motor will pull significantly higher amps than it is rated for and will overheat/burn out. If you want to be scientific you can look at the side of the motor and read the rated amps. Then with a load meter hooked up, run it and block off the air flow until the amp draw drops to or close to the rated amps.Centrifugal fans are amazing at moving a large quantity of air and the output can be ducted unlike axial.

    Watch the DIY Homemade Centrifugal  Garage Fan from Furnace Blower Video