DIY Video: How to build a Homemade Solar Heat Pump System to heat your home through the winter

     



    RECENT POSTS YOU MIGHT LIKE
    • DIY Video: How to build a Band Sawmill from scratch in your backyard and save a lot of money. Step by step build instructions.
      This video series shows the step by step build of a homemade Band Sawmill from scratch in your backyard.Harvesting and processing the wood that grows on your property is the dream of many homesteaders. The dream can be expensive (around $5k) because you need a sawmill in order to rip the wood and remove the bark.Instead of spending years saving up, you can spend less by building your own saw mill.it’s a tool you’ll use for years to come, and will more than pay for itself the first time you use it. Lumber isn’t cheap, and if you’ve got the natural resources and access to those resources, it makes the most sense to save money, time, and effort by using what you have available.

      Watch the DIY step by step build of the Band Sawmill series

    • How to build a Backyard Waste Oil Burner Powered Water Heater to produce Free Hot Water for your Home
      This projects goes over the build of waste oil powered free hot water heater for your home .This converts an old used domestic water heater to run on waste oil, engine oil or cooking oil. With as little as one liter of waste oil, this heater gives twice the heat output than a domestic electric powered water heater .As waste oil is free, this is more economical than running on gas or electric. The setup of this waste oil heater is very simple and easy. We have a waste oil burner that is placed under the domestic water heater. The burner is connected to a blower from a car. This blower is powered by a 12V battery charger . The burner is also connected to a drip feed waste oil pipe through a small pipe. The oil feed from a suspended tank, which gives it a gravity feed dribbles into the inlet pipe on the burner and it is simply blown into the burner by the force of the air from the blower. To control the oil flow ,we have a valve on the oil tank. The cold water comes into through the inlet hose at the bottom of the tank . From there burner just fires the heat up through the center of the heater as it would normally if it was gas fired. The hot water comes out from a outlet hose at the top of the tank. The waste oil burner is made out an old fire extinguisher bottle. The beauty of using extinguisher bottles is you don't have to worry about any flammable gases in them, and the metal seems to be quite durable. Make sure that the air and the fuel enter the bottle at a slight angle in order to create some swirling. This makes sure that the air and the fuel mix and will burn completely. And also that the bottle is kept hot so that the liquid oil will vaporize and the gas will burn. The inlet pipe for the waste oil and the blower is positioned at 25 to 35% of the way up to the bottle. The inlet pipe has a small bend in it so as to promote swirling within the bottle. This is important in keeping the bottle hot and self sustaining. The burner has a clean burn with almost no smoke. The output of the oil burner can be controlled by the amount of waste oil being dripped into the burner and by the amount of air blown into it. This oil gas burner is more powerful than a gas burner and the heat produced can overpower the heat sink threshold of the water heater . A vent line is installed on the system so that any build up pressure can be released. Apart from heating hot water , this set up can be used for space heating , pool heating or garage heating. https://www.youtube.com/watch?v=L4xq_GSjWLI
    • DIY Video: How to build your own Water Pump From Scrap and save lots of dollars
      This video shows the build of a Water Pump From Scrap .Today I dig into our scrap pile to come up with enough parts to build ourselves a gasoline powered water pump. I first start off with an old gear pump I had laying around, then I salvage an old pressure washer base to mount everything on. To power this water pump I use that two horse engine I bought at a yard sale. build everything out of free find junk that would have gone to landfill or scraped, at least these useful parts can now have a new lease on life.

      Watch the DIY Water Pump From Scrap build video