DIY Video : How to build a Powerful Mini Box fan for or off-grid use, camping, emergencies or everyday use

     



    RECENT POSTS YOU MIGHT LIKE
    • DIY Video : How to Repurpose an Old Water heater into a Foundry Furnace. Easy to build,Heat up quickly and efficient
      This Video series shows how to Repurpose an Old Water heater into a Foundry Furnace.This is a great way for the do-it-yourselfer to build a foundry furnace that will last a long time, heat up quickly, be fuel efficient, easy to build, and not break the bank!.The materials needed for this build are Old Water heater,Non-firing refractory,100HT ceramic coating,Ceramic blanket.

      Watch the Old Water Heater Foundry Build Series here

    • How to generate Free and Emergency hot water for your house by building a Waste Oil powered water heater
      This Video shows the build of a water heater from an old gas hot water service and converted it to run on waste oil instead of gas.The system could easily be set up in an off grid or prepper type location as it only needs a small amount of 12V power to supply the car blower I used here. The burner runs on any waste oil and is gravity fed without the need for Nozzles, pumps or compressors. As well as providing Domestic hot water, the output can also be used in a home heating system which is what I plan to set up for my home this winter.It could also be used for an outdoor shower, to heat water for animal troughs, to heat a spa or small swimming pool or other uses to replace gas or electric how water heating.

      Watch the DIY Homemade Waste Oil powered Water Heater Build

    • How to build a Homemade Wooden Bandsaw Mill from Scratch.Step by step build Instructions
      This video series shows the build of a Homemade Bandsaw Mill from Start to finish.The design for the saw is a good one, in that it was rock solid as it was making the cuts. Making the saw itself move as opposed to moving the wood through it would really make the build a lot more complex. Beefing up the frame to resist movement (chatter) while cutting through 16" of hard maple would be difficult, especially if the height was also adjustable.Using a stick to lever the wood through the saw was a very good way to regulate a steady feed rate and took little effort. For serious cutting in green, thick hardwood, a 2hp motor doesn't really "cut" it. To make the cutting more efficient (read faster), the blade speed should be very high - as high as 6000 fpm - and a motor that size doesn't have the power. A 6-8 hp gas engine would be much better

      Watch the DIY Homemade Wooden Bandsaw Mill Video series