DIY Video : How to build a Homemade Multi Use Water Purifier that uses no electricity .Works as Water heater and stove burner too….



    RECENT POSTS YOU MIGHT LIKE
    • How to build a Simple Survival Water Distiller using Bottles
      This video shows the build of a Simple Solar Water Distillation System for survival/SHTF situations.This is made using 2 clear (plastic or glass) bottles and glue (or tape).Fill one bottle with dirty/or saltwater,then connect the second bottle and set in the sun.Within a few minutes the water begins to evaporate and the other bottle collects the clean distilled water vapor.make sure the bottles have an airtight connection. prop up bottles at a slight angle so as the dirty/or saltwater starts to evaporate - the max. amount of water vapor will travel up to the higher collection container. works best in bright sun.

      Watch the DIY homemade Survival Water Distiller Build

    • DIY Video : How to build an Ammo Can Double Burner Rocket Stove from scratch . Step by step Build Video Instructions
      This video shows the step by step build of a Double Burner Rocket Stove made from an Old Ammo Can.The can is around 19″ x 10″ x 10″, I use vermiculite as insulation, some use sand instead but I like vermic as it is fairly light.If you remove some of the insulation and it’ll be a mini barrel stove for heating too.Here i use a Black and Decker Scorpion saw to cut the pipes and just a cheap bi-metal hole saw to do the holes. I’ve cooked a full steak dinner in the woods on it and it worked great.

      Watch the Homemade Ammo Can Double Burner Rocket Stove build

    • How to build a Homemade Hydronic Heating System that can lower your power bill, save heating cost, and could easily be powered in an emergency situation
      This video shows the build of a Home heating system that heat via hydronic (heat produced with water).This hot water heating system us typically installed at the baseboard or, at the very least, a point low to the ground. Since heat naturally rises, placing the heating element at the lowest point in a room is an easy way to evenly heat the air in a space.The hot water in the system is obtained from a boiler in a utility room, and this boiler is heated by gas, oil, or electricity. The hot water is pumped through a system of pipes that are installed in the baseboard. The heat from this hot water is transferred to the room, and once the heat transfer has cooled the water down again, it's piped back to the boiler room, replaced by a fresh influx of hot water, and reheated.

      Watch the DIY Homemade Hydronic Heating System Build Video