DIY Video : How to recycle your Waste motor oil,transmission oil or any waste fuel into 100% Re-Usable Fuel

Part 1 :

Part 2 :

This video is about how to heat large amounts of oil  in order to lower its viscosity so the centrifugal filter process works better.



RECENT POSTS YOU MIGHT LIKE
  • DIY Videos :How to generate Free Power for the rest of your life by building a Micro Hydro Electric Power system and kiss the Grid system goodbye.
    This 16 part Awesome Video series shows the overview and setup in detail of a Micro Hydro Electric Power System build for the long term from the ground up.What a hydroelectric system does is that it converts the force from flowing water into electricity. You take the kinetic energy of water flowing downhill from a stream or river and direct it onto a wheel in a turbine that converts the rotational energy to electricity. I have 2 natural springs that provide water which falls about 500 vertical feet through a mile of pipe and develops about 220 psi..Harness the power of hydropower; flowing water for clean, sustainable home free electricity 24/7 and ditch your dependency on the grid system for good. [the_ad id="6435"] The basic components of this build are A Stream Of Flowing Water - A hydroelectric generator is only useful in a bed of flowing water,Magnets - The magnets will spin against the coils to create an electric current.Bearing - Used for the disc to spin against,Coils - The coils will spin against the bank is to create an electric current.Half-Inch PVC Pipe - The disc will be placed on the PVC pipe.5-gallon bucket,Waterline - We are using the 5-gallon bucket and waterline to create a closed system. The overview of the steps mentioned in this video series: The first step in creating your hydroelectric generator is to create the discs. There are two parts to the disc, the stator and rotator disc. The stator disk is stationary and contains the coils. The rotator disc will be spun using the water current. The magnets will spin against the coils, creating an electric current. Now that we know the process, it is time to learn how you can make a hydroelectric generator yourself. You can create these discs using templates that you can find online. Trace the amount uncovered and use them as templates to cut the discs that you will be using. Make a hole in the discs ½ inch wide, so the half-inch PVC pipe can fit through the center of them. Place the discs side-by-side and attach the fins to the turbine. Attach the turbine to the rotator disc so it spins as the turbine spins. Make sure the fins are facing into the flow of water so that they will be pushed as the water passes through them. Next, attach the coils to the stator and at the magnets to the rotator disc. When you add the magnets, alternate them with their North and South poles. Make sure each north facing magnet is next to two south facing magnets. Likewise, make sure each south facing magnet is next to two north facing magnets. Add the turbine, rotator disc, and stator disk to the PVC pipe and rest it on top of the bucket. Pour water over The fins and the turbine will begin spinning. As the turbine spins, it will begin producing current as the bank is passed across the coils.
    Watch the step by step Micro Hydro Electric Power station Build Series

  • DIY Video: How to build a Homemade Hot Water Off grid Air Heater using Heat Exchanger and a Car Radiator Fan
    This video shows the build of a Homemade Hot Water Air Heater using an old heat exchanger and a car radiator fan.This unit provides near-instant warm air.The Air-Flow: it's adjustable from 10 CFM to 1500 CFM. max breeze 20 Mph! The Temps: With input water temps between 120F to 150F the output air temp ranged from 85F to 110F. *or from heat pump temps up to near furnace temps! easily warms a room or two, maybe more.The heart of the unit is an 8x8 Copper/Aluminum Heat Exchanger., This unit can easily be run straight from a 12v solar panel or battery so it's "off-grid" ready. Simply mounted the fan in front of it,then connected the pipes. then you just connect a small water pump (200-350 gph) to one of the pipes and drop both pipes into a water-filled sink,almost immediately it creates very warm air (in under a minute).

    Watch the DIY Homemade Homemade Hot Water Off grid Air Heater Build Video

  • How to build a Simple Homemade OFF GRID Refrigerator from easily available materials
    This video shows the build of an OFF GRID Refrigerator from cheap and easy to find materials.This design uses both the cooling effect of evaporation, and two water cooled condenser coil's. The fridge is shown using both a water ram pump at the end, and an electric pump powered by 12 volt/solar, it only uses 8 watts an hour using electric.There is an air gap between the sheet and the wall of the fridge because the water running down the sheet wont evaporate as well and that the water temp is not as low as the evaporative temp so the water touching the cooler could increase the temps and limit some of the potential cooling. If the power goes out and the fridge doesn’t keep things cool anymore – what other options do we have? If you are trying to live off grid and have no power source – how can you keep food and certain medicines cool and usable for longer?Then this Offgrid Refrigerator  is the answer.

    Watch the DIY Homemade Efficient Offgrid Refrigerator Build Video