DIY Video:How to build an Easy to make,light,Strong Chainsaw Mill from start to finish.


    Harvesting and processing the wood that grows on your property is the dream of many homesteaders. The dream can be expensive (around $5k) because you need a sawmill in order to rip the wood and remove the bark.Instead of spending years saving up, you can spend less by building your own saw mill out of a chainsaw!.This video shows the build of an easy to make,light and strong Chainsaw mill from scratch.You will need some 2mm,3mm square pipes, coarse threads,bolts,spring washers

    Watch the DIY Homemade Simple Chainsaw Mill Build



    RECENT POSTS YOU MIGHT LIKE
    • How to generate Free and Emergency hot water for your house by building a Waste Oil powered water heater
      This Video shows the build of a water heater from an old gas hot water service and converted it to run on waste oil instead of gas.The system could easily be set up in an off grid or prepper type location as it only needs a small amount of 12V power to supply the car blower I used here. The burner runs on any waste oil and is gravity fed without the need for Nozzles, pumps or compressors. As well as providing Domestic hot water, the output can also be used in a home heating system which is what I plan to set up for my home this winter.It could also be used for an outdoor shower, to heat water for animal troughs, to heat a spa or small swimming pool or other uses to replace gas or electric how water heating.

      Watch the DIY Homemade Waste Oil powered Water Heater Build

    • How to build a Simple Survival Water Distiller using Bottles
      This video shows the build of a Simple Solar Water Distillation System for survival/SHTF situations.This is made using 2 clear (plastic or glass) bottles and glue (or tape).Fill one bottle with dirty/or saltwater,then connect the second bottle and set in the sun.Within a few minutes the water begins to evaporate and the other bottle collects the clean distilled water vapor.make sure the bottles have an airtight connection. prop up bottles at a slight angle so as the dirty/or saltwater starts to evaporate - the max. amount of water vapor will travel up to the higher collection container. works best in bright sun.

      Watch the DIY homemade Survival Water Distiller Build

    • How to build a Simple Homemade Water Distiller that turns dirty water/salt water into clean fresh pure water
      [the_ad id="6432"] This video shows the build of a "pure water" Water Distiller that easily turns dirty water/salt water etc... into clean fresh pure water. This produces lots of clean water fast. Made from close to 12 feet of copper tubing along with a few fittings (optional stainless steel tube shown as well). video contains full instructions on how to build it. Early testing shows it produces about a quart in 1.5 hrs (and half gallon in 2.5 hrs). note that i soldered on the copper fitting. If you don't have a torch, they sell "push on" fittings that require no soldering. *if soldering, remember to use "lead-free" solder.The process is simple. It boils water and creates steam. The steam rises without bringing any of the impurities along with it. The steam travels through the coils and slowly cools and condenses. It finally condenses back to its liquid form and drips out as clean water.

      Watch the DIY Deluxe Pure Water Distiller build