DIY Video:How to build a Simple Homemade Wind Generator from Old Ceiling Fan ,Microwave Oven Parts ,Old TV Antenna and other free junk


    This video shows you how to build a DIY Wind Generator using Old Ceiling Fan parts ,Microwave Oven Parts ,Old TV Antenna and other free junk that is laying around. Small wind turbines are electric generators that use the energy of the wind to produce clean, emissions-free power for individual homes.Everyone can generate their own power and cut their energy bills while helping to protect the environment. Unlike utility-scale turbines, small turbines can be suitable for use on properties as small as one acre of land in most areas of the country.Small-scale renewable energy is a must for a sustainable home.Using only a ceiling fan, a microwave oven, and a few other spare parts, you will be able to make your very own homemade wind generator

    Watch the DIY Homemade Wind Generator built from Old Ceiling Fan



    RECENT POSTS YOU MIGHT LIKE
    • DIY Video : How to Dig a Shallow Well from Scratch.Step by step Video Instructions
      This video shows How to dig a shallow well on your property from dowsing to digging to capping. This shallow well will provide water for our bees and supporting plants. This dig uses a modified hand auger and took about 4 hours to complete (17 feet with nearly 4 feet of water).Learning how to dig a well is a good lesson that every prepper should master.Even if it doesn’t come to a survival scenario, having your own water supply means that you’re basically off the grid. You’re not dependent upon third parties.

      Watch the Shallow Well Digging Video Instruction

    • DIY Video: How to build a Homemade Solar Heat Pump System to heat your home through the winter
      This Video shows the build of a DIY Solar Heat Pump System .An air source heat pump consists of an evaporator coil, a condenser, two fans, a compressor, and plumbing lines containing a refrigerant. In simple terms, during the winter the large fan in the outdoor unit pulls cool outdoor air through the evaporator coil which causes the refrigerant inside to absorb what's called 'latent heat' from that air, and then begins to boil and evaporate . Once the refrigerant is up to temperature, it passes through the condenser coil/heat exchanger where indoor air also passes through the condenser's fins to absorb the heat from the refrigerant and deliver it where it's needed.A heat pump is essentially an air conditioner working in reverse. Instead of pumping heat from indoors to outdoors, it's pumping heat in reverse.

      Watch the DIY  Solar Heat Pump System Build Video

    • DIY Video :How to build a Wood Stove that runs a generator, produces gasoline,runs a fridge and act as a water heater at the same time
      This Video shows one of the most efficient wood stove on the planet it will make gasoline run a generator and a propane fridge, heats hot water and your home at the same time.This Stove can burn all paper and plastic trash, cow dung, wood, grass and even dry human waste plus just about every other dry organic compound. The bio-digester manure can be burnt after it produces methane for you and used as Syn-Gas.To construct a perfect wood stove, you have to collect all the important components, with which the device should be built up. You'll need Barrel,Stovepipe,Driller,Braces,Welding gloves.Generally, it is said that the efficiency of wood may vary from one model to another. However, still, with the above method, you can design the best stove, which can not only operate a generator and fridge but also forms gasoline. If your stove is in hotter condition, it may be easier to break down the fuel into smaller particles at the time of burning.

      Watch the homemade DIY Multipurpose Wood Stove build Video