This video shows the build of a Homemade Ammo Can Rocket Stove that is so efficient that it can burn wood without producing smoke thanks to its secondary burn system and insulated burn chamber.Due to its large primary air intake pipe and its rockwool filled, double skinned construction, this ammo can stove also functions as a ‘rocket stove’. Once it is up to its working temperature, fuel can be added without having to open the door of the stove.This ammo can stove is tiny, easily portable, cheap to build, and yet burns wood so efficiently that it produces virtually no smoke.
- DIY Video : How to build a Homemade Atmospheric Water Generator . Produces/Extracts Distilled Water from the airThis video shows the build of a Homemade DIY Atmospheric Water Generator!.ThisUnit pulls Pure 'distilled water' straight out of the air. This simple design pumps near freezing water thru a long section of copper coil. Coil becomes very cold and dew (condensate) forms on the coil. The dew is then caught by a drip-pan located beneath the coil.This unit has the added benefit of dehumidifying the air.I used only aluminum and copper in this version. main thing with these is to keep the coils clean. if coils are cleaned after each use, the water generated is 'distilled water.
- DIY Video : How Generate Unlimited Hot water without electricity by building a Homemade Underwater Wood StoveThis video shows the generation of Unlimited hot water 100% Off the Grid without electricity by converting an old propane tank to burn underwater as an immersion heater for a lot of hot water.Here,I use a homemade underwater wood stove to make a lot of hot water in a relatively short time.I also make use of the waste heat to cook breakfast.Almost 75-80 gallons of hot water in 1 hour with wood.Really a great way to heat a lot of water.
- How to build a Simple Homemade Water Distiller that turns dirty water/salt water into clean fresh pure water[the_ad id="6432"] This video shows the build of a "pure water" Water Distiller that easily turns dirty water/salt water etc... into clean fresh pure water. This produces lots of clean water fast. Made from close to 12 feet of copper tubing along with a few fittings (optional stainless steel tube shown as well). video contains full instructions on how to build it. Early testing shows it produces about a quart in 1.5 hrs (and half gallon in 2.5 hrs). note that i soldered on the copper fitting. If you don't have a torch, they sell "push on" fittings that require no soldering. *if soldering, remember to use "lead-free" solder.The process is simple. It boils water and creates steam. The steam rises without bringing any of the impurities along with it. The steam travels through the coils and slowly cools and condenses. It finally condenses back to its liquid form and drips out as clean water.