DIY Video : How to convert FREE JUNK into a Homemade Exercise Bike Generator

    This Video shows how you can make a Homemade Exercise Bike Generator, made from Free Junk. This generator is built with free find parts found on the curb side.The lawn mower motor is out of a basic plug in mower and the pulley was off a GM alternator, belt is from a 80s Toyota.Building a DIY bicycle generator helps you stay in shape(something that’s essential to survival) and also generates some useful electricity to recharge your electronics off the grid. That’s what we call killing two birds with one stone.

    Watch the DIY Homemade Exercise Bike Generator Build Video



    RECENT POSTS YOU MIGHT LIKE
    • DIY Video : How to build an Off Grid DIY 12 Volt Washing Machine from junk parts and pieces laying around
      This video shows the build of a homemade 12V washing machine made from junk parts and pieces laying around.Most of the materials you’ll need can be found around your house and most certainly at your local hardware store.Great for going off grid for a while preparing to be survive in case of SHTF or are you just a regular old camper that needs clean clothes at camp.Laundry has come up a number of times as a self-sufficiency topic. It makes sense for a couple reasons. First of all, because many people in our crowd are wanting to be self-sufficient of the electrical and water grids, and need find another way of washing clothes. Secondly, because we are also usually looking for ways to save money.

      Watch the DIY Off Grid DIY 12V Washing Machine build video

    • DIY Video:How to build an awesome Roof Top Portable ABS Pipe Hot Water Heater/Shower . Great for Camping/ Outdoors
      This video shows the build of a DIY solar powered, pressurized, roof top water heater and shower.This is done using an ABS 4 inch pipe, 6 feet long, which would give me a capacity of 15 Litres or 4 US gallons.This is an easy and inexpensive project that required minimal tools and just some basic plumbing parts.I started by installing the shutoff valve. I wanted the drain to be as low as possible in the pipe to avoid necessity of having to tilt the system. To ensure the valve retaining nut did not interfere with the pipe once it is glued into the, I positioned the nut away from the wall of the cap using a bolt, which is the same thickness as the wall of the pipe.I drilled out a 2” threaded cap and tapped in a radiator valve drain plug that I picked up at the local automotive parts store. This valve will allow me to release pressure from the tank should that be necessary without opening the drain shutoff. Also when open, this will allow a gravity fed system through the drain valve should for some reason I not have access to the air compressor.As a final step to improve thermal absorption of solar energy, I painted the surface with flat black paint. First I lightly buffed all the ABS surfaces with steel wool soaked Methol Hydrate. Then applied one coat of spray primer followed by two coats of flat black paint.

      Watch the DIY Homemade Inexpensive Roof top Solar ABS Pipe Hot Water System Build Video

    • How to build a super Efficient Wood Burner from start to finish .No smoke and Clean Burn
      This Video series shows the build of a wood burner/heater from an gas cylinder from start to finish.The video begins by explianing the cutting of flue /ash pan hole in top and bottom. Main materials from the local scrapyard made new.Then door is cut out, door frame built,secondary air pipework,flue deflector plate.The next in the series shows the fitting flue deflector plate,drilling bending and fixing the les,grinding all old welds off, making lifting handles,flue outlet and drilling the secondary air intake hole,making the door hinges,cutting hole out for glass in door,welding secondary air intake pipes in.The series ends with making the secondary air intake,door frame welded,primary air damper built and welded on.A Test burn is shown at the end.

      Watch the build of a Homemade Efficient Wood Burner from scratch