How to build a Simple Homemade Bandsaw Mill from Old Car Wheels



RECENT POSTS YOU MIGHT LIKE
  • DIY Video:How to build a Simple Homemade Wind Generator from Old Ceiling Fan ,Microwave Oven Parts ,Old TV Antenna and other free junk
    This video shows you how to build a DIY Wind Generator using Old Ceiling Fan parts ,Microwave Oven Parts ,Old TV Antenna and other free junk that is laying around. Small wind turbines are electric generators that use the energy of the wind to produce clean, emissions-free power for individual homes.Everyone can generate their own power and cut their energy bills while helping to protect the environment. Unlike utility-scale turbines, small turbines can be suitable for use on properties as small as one acre of land in most areas of the country.Small-scale renewable energy is a must for a sustainable home.Using only a ceiling fan, a microwave oven, and a few other spare parts, you will be able to make your very own homemade wind generator

    Watch the DIY Homemade Wind Generator built from Old Ceiling Fan

  • How to build a Simple Homemade Water Distiller that turns dirty water/salt water into clean fresh pure water
    [the_ad id="6432"] This video shows the build of a "pure water" Water Distiller that easily turns dirty water/salt water etc... into clean fresh pure water. This produces lots of clean water fast. Made from close to 12 feet of copper tubing along with a few fittings (optional stainless steel tube shown as well). video contains full instructions on how to build it. Early testing shows it produces about a quart in 1.5 hrs (and half gallon in 2.5 hrs). note that i soldered on the copper fitting. If you don't have a torch, they sell "push on" fittings that require no soldering. *if soldering, remember to use "lead-free" solder.The process is simple. It boils water and creates steam. The steam rises without bringing any of the impurities along with it. The steam travels through the coils and slowly cools and condenses. It finally condenses back to its liquid form and drips out as clean water.

    Watch the DIY Deluxe Pure Water Distiller build

  • How to build a super Efficient Wood Burner from start to finish .No smoke and Clean Burn
    This Video series shows the build of a wood burner/heater from an gas cylinder from start to finish.The video begins by explianing the cutting of flue /ash pan hole in top and bottom. Main materials from the local scrapyard made new.Then door is cut out, door frame built,secondary air pipework,flue deflector plate.The next in the series shows the fitting flue deflector plate,drilling bending and fixing the les,grinding all old welds off, making lifting handles,flue outlet and drilling the secondary air intake hole,making the door hinges,cutting hole out for glass in door,welding secondary air intake pipes in.The series ends with making the secondary air intake,door frame welded,primary air damper built and welded on.A Test burn is shown at the end.

    Watch the build of a Homemade Efficient Wood Burner from scratch