DIY Video:How to Build a Homemade Low Flow Ram Pump that can pump water without Electricity from very low flow creeks ,river.



    This video shows you can pump water from a very low creek or water source without any electricity by building a Simple Low Flow intake Ram Pump.This is ideal for any low flow creek,spring with around 30 gal per minute flow rate.This Ram Pump will need a continuous flow of water to operate. Determining the flow rate will help determine the size pump that you need.Measure your gallons per minute by placing a 5 gallon bucket in the water and collect all the water while timing how long it takes to fill the bucket and divide the gallons of water by the time in seconds and then multiply by 60 seconds to get GPM

    Watch the DIY Homemade Low Flow Intake Ram Pump build Video



    RECENT POSTS YOU MIGHT LIKE
    • How to build a Simple and Efficient Homemade Garage Fan out of Old Furnace Blowers
      This video shows the build of a Homemade Garage fan made out of Old Furnace blowers that is easy to make and really efficient.Once you try one of these you'll never use a box fan again. These fans are designed to run with constant restriction. So you need to recreate this when used out in the open by blocking roughly 25% of the air intake or output. If you don't restrict the airflow the motor will pull significantly higher amps than it is rated for and will overheat/burn out. If you want to be scientific you can look at the side of the motor and read the rated amps. Then with a load meter hooked up, run it and block off the air flow until the amp draw drops to or close to the rated amps.Centrifugal fans are amazing at moving a large quantity of air and the output can be ducted unlike axial.

      Watch the DIY Homemade Centrifugal  Garage Fan from Furnace Blower Video

    • DIY Video : How to build an Off Grid DIY 12 Volt Washing Machine from junk parts and pieces laying around
      This video shows the build of a homemade 12V washing machine made from junk parts and pieces laying around.Most of the materials you’ll need can be found around your house and most certainly at your local hardware store.Great for going off grid for a while preparing to be survive in case of SHTF or are you just a regular old camper that needs clean clothes at camp.Laundry has come up a number of times as a self-sufficiency topic. It makes sense for a couple reasons. First of all, because many people in our crowd are wanting to be self-sufficient of the electrical and water grids, and need find another way of washing clothes. Secondly, because we are also usually looking for ways to save money.

      Watch the DIY Off Grid DIY 12V Washing Machine build video

    • DIY Video: How to build an Efficient Cold Water Powered Radiant Air Cooler that uses no electricity. Turns Cold Water into Cold Air!!
      This video shows the build of a simple Homemade Water-Chilled" Radiant Air Cooler! w/motor speed control!.Made with an 8x8 "water-to-air" heat exchanger, small water pump and a 7" fan. This new design cools air by pumping ice-water (or cold water) thru a water-to-air heat exchanger (copper/aluminum radiator) and then drawing the warm air thru the unit using a 12v radiator fan. the air that is produced is cooled dramatically with no increase in humidity and no need to vent any part of the unit to the outside. the heat is essentially captured into the cold water and the "cold" in the water is released into the room as cold air.

      Watch the DIY Homemade Offgrid Radiant Air Cooler Build Video